Daily Maintenance Of Pipe Laser Cutting Machine

1. Check the protection lens cleanliness : 

Unclean please clean in time ; please replace the ones with burning points affecting use in time. ( Note protective mirror drawer out, to ensure that there is no dust on site, and timely use of American paper or special plug, effectively seal the protective mirror window ). 

2. Check the copper mouth : 

Copper mouth irregular, obvious scars recommended timely replacement. 

Each replacement of the copper nozzle requires floating head calibration and inspection center. 

3. Check whether the ceramic ring is loose : 

The loosening of the ceramic ring will affect the stability of the cutting operation of the equipment. Tighten the ceramic ring locking ring by hand. 

4. Inspection center : 

To ensure that the laser head coaxial, using transparent tape adjustment, try to use a small nozzle ( such as 1.0 ), so more accurate. 

5. Capacitor calibration : 

Daily start-up machine performs capacitance calibration, tool-elevation monitor-F1-2. 

6. Back to the origin and calibration B axis center : 

The daily start-up machine performs back to the origin action and calibrates the B-axis center.

7. Check the gas source : 

Check whether the residual gas source to meet the production, gas leakage phenomenon. Check the outlet pressure value of the gas storage tank before the daily shift, and drain the gas storage tank. 

8. Clean the chuck : 

Clean compressed air after work every day, clean the dust and iron cutting in the chuck and lubricate and organ cover. As shown in the following figure : 

9. Vacuum tube : 

Check the vacuum tube daily for damage and loosening.