How To Properly Use A Exchange Table Laser Cutting Machine

Sheet metal cutting is one of the manufacturing commonly used in industrial manufacturing, almost any product needs to use sheet metal. With the development of China's economy, the improvement of people's living standards, a variety of electrical appliances, automobile demand continues to skyrocket, thus allowing the demand for metal processing continues to increase. Metal processing industry in the electrical control box, machine shell, car shell, fender, etc. are sheet metal parts, their complexity is relatively high, some parts of the process to dozens of more, in response to the complexity of the product, the exchange table laser cutting machine performs better.

Exchange table laser cutting machine using fiber laser, photoelectric conversion efficiency of up to 40%, cutting speed, high productivity. The fiber laser outputs a high energy density laser beam and gathers it on the surface of the workpiece, causing the area of the workpiece irradiated by the ultra-fine focus spot to melt and gasify instantly. The output wavelength of the fiber laser is 1/10 of the CO2 wavelength, and the output beam is of good quality and high power density, which is very conducive to the absorption of metal materials, and has a strong metal cutting ability.

Here we come to understand the operation of the exchange table laser cutting machine:

1.To determine the material to be processed, the sheet metal material will be fixed flat on the processing machine bed, and then determine the smoothness of the material placement, so as not to jitter in the cutting process, resulting in the de-cutting accuracy can not meet the requirements.

2.After starting the machine, you should manually start the machine in X and Y directions at low speed to check and confirm that there are no abnormalities. For the new workpiece program input, should first test run, and check its operation.

3.Operate the console, input the product cutting pattern, and the thickness of the cutting material and other parameters, and then adjust the cutting head to the appropriate focus position, and then reflect and adjust the nozzle centering.

4.When working, pay attention to observe the operation of the machine, so as not to cut the machine out of the effective range of travel or two collision caused by accidents.

5.Start the voltage regulator and chiller, set the water temperature of the chiller and water pressure.

6.Start the laser, and then turn on the machine.