The Processing Method Of Hanging Slag When The Workpiece Is Processed By The Laser Cutting Machine

When using a laser cutting machine for cutting, sometimes the problem of cutting on all sides is sometimes inconsistent, that is, a slag on one side, no slag on three sides, or dregs on both sides, and there is no residue on both sides. This problem affects cutting quality and production efficiency. Below we will discuss the possible causes of this problem and provide corresponding solutions.
1. Coaxial incorrect axis
If the laser is not in the center of the nozzle, it may cause inconsistency on the cutting sides. This is because the focus of the laser has a great impact on the cutting accuracy. To solve this problem, the laser nozzle needs to be adjusted and the nozzle is installed in the center of the center.

2. Nozzle damage
The condition of the nozzle may also affect the cutting quality. If there is a gap between the nozzle, or the shape is no longer round, it may cause the problem of inconsistent cutting on all sides. In this case, you need to replace a new nozzle.

3. The problem of cutting head verticality
If the installation of the cut head is not vertical, it may also cause the problem of inconsistent cutting on all sides. This is because the position of the cut head will affect the focus effect of the laser. To solve this problem, you need to check and adjust the installation position of the cut head to ensure that it is vertical.

4. Losterity problem
If there is a problem with the lens inside the cut head, such as small black spots or a layer of material coverage, and these problems only appear on the side of the lens, then it may also cause the problem of inconsistent cutting sides. To solve this problem, you need to check the condition of the lens regularly and clean or replace it if necessary.

5. Laser problem
If the conventional reasons are repaired, but the problem still exists, the problem of laser may be considered. This problem may require professional laser maintenance technicians for inspection and processing.

6. Light quality problem
This problem often appears in equipment above 10wat. If the quality of the laser is not good, it may cause inconsistency of cutting on all sides. In this case, it may be necessary to contact the fiber laser cutting machine supplier to seek professional technical support.
The problem of inconsistent laser cutting may be caused by various factors. Through careful inspection and solving the possible problems above, the cutting effect can be effectively improved. It should be noted that the solution of this problem may require professional technical knowledge and experience. If you encounter difficulties when dealing with this problem, it is recommended to seek professional technical support.