What Is The Cause Of The Cutting Shape Of The Metal Optical Fiber Laser Cutting Machine?

Cutting round holes on metal sheets and pipes is a common process, but some customers have purchased metal laser cutting machines and found that the round holes cut by laser cutting machines are not round. It's a matter of equipment or process.
More and more metal processing enterprises began to choose laser to cut round holes. The machining section is smooth, the diameter can be changed at any time, and the operation flexibility is high. However, with modern processing methods, a skilled operator is required. Improper operation will result in irregular shape.
1. It may be that the light intensity is not adjusted well, resulting in no overlap at the end.
2. Then look at your hardware: whether there is a problem with the beam, lens, nozzle, etc.
3. Check whether the servo motor or cutting head is fixed and loose.
4. The blowing air pressure is not appropriate.
In the process of blowing, when the wind pressure is too low, the edge will be scraped and carbonized, while the pressure is too high, it is easy to burst the hole. Therefore, this requires the perfect cooperation between the process proofing engineer and the machine, and the right air pressure is selected according to experience, so as to make the round hole more full.
5. The parameters of the servo motor are wrong.
Elliptical or irregular phenomena sometimes appear in the round hole, which is related to the mismatch of XY axis motion, and the direct cause of the mismatch of XY axis motion is the improper adjustment of servo motor parameters. Therefore, the quality of the cutting round hole also has certain requirements for the servo motor.
6. Resulting in precision errors of guide rail and lead screw.
If the parameter error of the servo motor affects the cutting quality, then the accuracy error of the guide rail and the lead screw will directly lead to the accuracy of the round hole not reaching the expected. This is related to the strength of laser cutting machine manufacturers. Usually, some small factories will deceive customers that the accuracy of the laser cutting machine can reach 0.1 mm, but in fact, in the actual operation process, the quality and effect of laser drilling will be poor. Therefore, it is necessary to choose a high-quality laser cutting machine of a large brand.
Four factors affecting the cutting accuracy of fiber laser cutting machine.
1. The size of the laser concentration of the laser generator: if the smaller the spot after aggregation, the higher the cutting accuracy, if the gap after cutting is also smaller. The fiber laser cutting machine has high precision and good quality. However, the beam from the laser is tapered, so the slit cut is also tapered. Under this condition, the greater the thickness of the workpiece, the lower the accuracy, so the larger the slit.
Second, the accuracy of the workbench: if the precision of the fiber laser cutting machine is very high, the cutting accuracy will also be improved accordingly. Therefore, the accuracy of the table is also an important factor in measuring the accuracy of the laser generator.
3. The laser beam is concentrated into a cone: When the fiber laser cutting machine cuts, the laser beam is conical downwards. If the thickness of the cutting workpiece is large, the cutting accuracy will be reduced, and the cutting gap will be larger.
4. Different cutting materials: cutting materials will also affect the accuracy of the fiber laser cutting machine. In the same case, the cutting accuracy of the fiber laser cutting machine for stainless steel and aluminum will be different, the cutting accuracy of stainless steel will be higher, and the cutting surface will be smoother.

