Which Fiber Laser Cutting Machine Auto Focus Or Manual Focus Is Better?

With the continuous improvement of production requirements, laser technology has gradually matured. The advent of new laser heads has changed the traditional manual focusing mode. Automatic focusing has successfully replaced the traditional focusing mode, and the new automatic focusing cutting head has been obtained. It is widely used.

The piercing focus of the manually adjusted cutting head cannot be adjusted, and the piercing focus is the same as the cutting focus. When piercing thick plates, the energy is insufficient and the piercing speed is slow. The auto-focusing cutting head can automatically adjust the focus during perforation, adjust the size of the focus during perforation, increase perforation energy, and increase perforation speed during perforation of thick plates.

From the perspective of perforation time, the speed of automatic focusing is half that of manual focusing, and the cutting effect is basically the same. However, autofocus will reduce the over-melting of the sheet due to the short material overheating time. The advantage of autofocus is obvious, which can significantly improve production efficiency and greatly reduce the perforation time of cutting thick plate materials. When processing workpieces of different materials and thicknesses, the machine can quickly adjust the focus to a suitable position.

Therefore, the automatic focusing fiber laser cutting machine is ahead of manual focusing in most aspects. With the advancement of technology, the automatic focusing laser cutting machine will be more practical and the processing effect will be more perfect, providing better help for laser cutting .

Company Introduction	Factory Visiting	Products	Application